EvoControl Ventilation – MPO1 Display

Testing of unit inputs, outputs and parts can be done manually.

Go to settings and enter the authorisation code 123321.

Test parameters are displayed and they can be switched on and off and display values.

• At control signal VVX the heat exchanger starts and runs in pulses after the control signal, (-1 = 100%).
• When a heating control signal is received, 230 Vac is also output at terminals 16 and 17.
• When a ‘cool’ control signal is received, 230 Vac is also output at terminals 17 and 18.

See Parameter settings.

To end the test, you must exit the menu by highlighting the “Back” line and pressing Enter.

Freeze protection is NOT active in “Test mode”